Ushering in a New Generation of Extruder

Extruder Heats Up Before Leveling By Iteself. (a) Twin‐screw extruder schematic and (b) extruder die configuration Download Scientific Diagram You can easily check that by opening a file in a notepad and see, that there will be a few lines describing the job, nozzle and bed setting temperature and the user code that is inserted in printer properties screen. I am using CURA as my slicer, and it sets the bed and nozzle temp before printer start code is executed

I am using CURA as my slicer, and it sets the bed and nozzle temp before printer start code is executed Among these advancements, you might notice a curious behavior in some printers where the extruder heats up before the leveling.

The solution to the problem of selfheating of the extruder (final tests). YouTube

March 14, 2025; 6:05 am; Jasonxue The technology behind 3D printing continues to evolve, offering more precision and automation Entre estos avances, es posible que notes un comportamiento curioso en algunas impresoras: el extrusor se calienta antes de que comience el proceso de nivelación. You can easily check that by opening a file in a notepad and see, that there will be a few lines describing the job, nozzle and bed setting temperature and the user code that is inserted in printer properties screen.

The solution to the problem of selfheating of the extruder (final tests). YouTube. Another interesting method that works to reduce your stepper motor overheating is to not use rafts that are too large Extruder Heats Up Before Leveling by Itself: A Deep Dive into the Process Jasonxue March 14, 2025 Blog Categories

Aluminum Extrusion Process. Vicky@Raise3D wrote:If you are not going to use Second Nozzle for the moment, comparing with leaving heater rod and temperature sensor out separately which makes the sensor can read actual heater's temperature to stop heating over limitation.I would more recommend you use the Single-Version firmware Not the one you asked but mine does the same thing